After flashing a stock ROM, this article will assist you in resolving the issue where your phone is stuck in Fastboot Mode. Utilising an open-source platform like Android has several advantages. With Android, you can perform a lot of things, including flash TWRP or use Magisk to acquire root access. But for many users, the ability to flash a custom ROM is the finest feature.

These modified ROMs may be used to update your OS for a longer time than your OEM’s and unlock a tonne of new features. They might be a difficulty at times. When that occurs, you may return to the standard environment using Fastboot Commands and an OEM-designated device. Even this procedure is not without its issues.

Concern about this was voiced by certain users. The stock firmware can be flashed successfully, however it is inoperable when the device is powered on. They seem to be caught in a boot loop. Having this issue is not a cause for concern. After flashing the stock firmware, the Fastboot Mode problem will be addressed in this tutorial. Let’s start now.

After Flashing The Stock Rom, The Phone Became Stuck In Fastboot Mode.

Disclaimer: For your convenience, the instructions below have been broken up into pieces. We won’t be held liable if your alarm goes off but you aren’t awakened by it or if your data is lost.

Step 1: Install The Android SDK

You must first install the Android SDK Platform Tools on your computer. The only one that Google officially recommends is this one, which is also the official ADB and Fastboot binaries. Download it, then extract it to a spot on your computer that is convenient for you. You will get the platform-tools folder as a result, which you will need for the remainder of this manual.

Step 2: Enter Fastboot Mode

Your device will likely already be booted into Fastboot Mode. In the event that this is not the case, you may need to use a workaround to boot into this mode. To do so, turn off the device and then boot it into Fastboot Mode by pressing and holding the Power and Volume Up buttons (or Volume Down on certain devices) for a few seconds. You [wouldn’t be able to execute the adb reboot bootloader command since you wouldn’t be able to access the OS].

Step 2: Clear Fastboot Fb_Mode.

1. First, use a USB cord to connect your device to the PC. Ensure that USB Debugging is turned on. (See how to make USB debugging available on a Xiaomi or other Android smartphone.)
2. Next, go to the platform-tools folder and press Enter after typing CMD in the address box. By doing this, the Command Prompt will open.

3. To clear the Fastboot fb_mode, execute the following command in the CMD window:

fastboot oem fb_mode_clear

4. After that is complete, use the command listed below to start the device’s operating system:

fastboot reboot

I’m done now. After installing the stock firmware, the phone should no longer be trapped in Fastboot Mode as a result of this. Now tell me, what did we just do? The fastboot oem fb_mode_set command, which tells the device to boot into Fastboot Mode, is what the device complies with by default. The device will now boot into the OS after we used the fastboot oem fb_mode_clear command to reset this mode. We conclude this guide on that tack. In the comments area, we welcome any and all of your questions.

Conclusion

It’s entertaining to flash both custom and standard ROMs, but if anything goes wrong, you might be locked in a boot loop or in bootloader mode. If your Android smartphone is stuck in fastboot mode after installing a stock ROM, the technique mentioned above should help. However, if the device is still having trouble launching, you may get in touch with us through our Telegram channel or by leaving a comment here.